Free hanging heat exchanger
There is no bottom plate under the heat exchanger. This allows the melt water to run off freely and prevents the formation of ice on the bottom of the unit – avoiding damage to the fan and heat exchanger caused by ice and power loss due to poor heat exchange.
Air source heat pump installation included.
Standard installation:
- installation up to 3 m high
- up to 5 m of insulated pipework
- drilling one 73mm hole in a wall up to 50 cm thick, except concrete
- exterior wall fixings, fasteners and vibration bushings
- cabling between interior and exterior up to 5 m
- condensate drainage up to 5 m
Additional costs are:
- Ground frame and base plate
- basket lift
- condensate pump
- installation of the electrical switchboard dispenser and cable run to the equipment.